You are here: Home > Husqvarna > Fork,Speed Bleed Button
Sort By:
Page of 1
The speed bleed buttons are a triple sealed push button valve assembly using two, piston and cylinder type o-ring applications in each valve to eliminate leakage of any kind, fluids or air in or out of the fork assembly.

They install in just 5 minutes (no modification). Remove the stock Bleed Screws and thread in the STR Bleed Valves with the supplied wrench.

Just 2 pounds of pressure can change the suspension balance front to rear. Often what is lost with pressure in the fork is that Plush feeling and the confidence that goes with it. So start by topping out your forks, then bleed off any built up pressure. This topping step is important so that you do not create a vacuum when they are topped. This condition would lower the front end ride height overall and alter your handling. *A low 3/8 installed standoff height.

4mm Thread - for White Power Forks - FITS: All Husaberg Models -2012, with WP fork
A dedicated version to fit the new WP 4CS fork. The same great dual valve system, that reliably gives you the ability to instantly bleed your forks.
A dedicated version / Kit, Fitting the new WP AER fork. The same great dual valve system, that reliably gives you the ability to instantly bleed your forks. With Two "piston and cylinder" style valves in each valve body, No air Gets past the Valve. The valve is cleaned as pressure is released down and out, past the dust cover / cap.

The performance of the WP AER fork in an offroad environment demands the highest quality leak proof product.